NOTE: Any button(s) of the transmitter may be used in place of the trunk symbol button for channel 3, however using the proper symbol will obviously be less confusing for the consumer."Repeat step 8 for each transmitter you wish to program".Press and hold the trunk/key symbol button of the transmitter you wish to program for 4 seconds or until a long chirp is heard from the siren, or the interior/parking lights flash.The dash mounted LED will Flash 3 times, indicating that the unit is ready to accept programming for the trunk release/ remote start, channel # 3 output. Press and release the valet push-button program switch once to advance to channel 3.NOTE: Any button(s) of the transmitter may be used in place of the unlock symbol button for channel 2, however using the proper symbol will obviously be less confusing for the consumer."Repeat step 6 for each transmitter you wish to program". Press and hold the unlock symbol button of the transmitter you wish to program for 4 seconds or until a long chirp is heard from the siren, or the interior/parking lights flash.The dash mounted LED will Flash 2 times, indicating that the unit is ready to accept programming for the disarm/unlock channel # 2. Press and release the valet push-button program switch once to advance to channel 2.NOTE: Any button(s) of the transmitter may be used in place of the lock symbol button for channel 1, however using the proper symbol will obviously be less confusing for the consumer."Repeat step 4 for each transmitter you wish to program".Press and hold the lock symbol button of the transmitter you wish to program for 4 seconds or until a long chirp is heard from the siren, or the interior/parking lights turn flash.To accept programming for arm/lock, receiver channel #1. The dash mounted LED will flash 1x indicating that the system is ready.Press and release the valet push-button program switch 3 times.Enter the vehicle, and turn the ignition switch to the on position.If you are programming to a keyless entry system, the interior and or parking lights may also flash. NOTE: In addition to the LED flash patterns listed below, If you are programming the transmitter to an alarm system, the siren will also chirp. Do not attempt to use this combination of buttons for any other purpose.
FCC ID ELVATOE CODE
Non alarm models will flash the parking lights only to confirm the transmitter code has been learned and stored.Īlso understand that the lock and the unlock buttons used in combination after arming are pre assigned for the shock sensor defeat function. This is indicated by a long chirp from the siren. If the 15 second time limit expires between steps, the unit will automatically exit the program mode. NOTE: It is important to remember that during the programming mode, each individual step must be completed within 15 seconds of the previous step.
Programming the Pursuit PROOE4BS Transmitter
0 kommentar(er)
